3D Printed: NFS RawGuard (Not For Sale)

Every collector has seen a card at a vendor table that catches their attention, only to find out it isn’t actually for sale.

The **NFS RawGuard (Not For Sale)** plays into the classic hobby joke of vendors putting desirable cards on display, but refusing to sell them when someone asks for a price.

Built around a standard toploader, the Not For Sale RawGuard gives raw cards the appearance of a graded slab while making their status immediately clear. The custom **“NFS — Not For Sale”** label instantly gets the joke across and is guaranteed to start conversations at card shows, game rooms, shops, or anywhere collectors gather.

Like the original RawGuard, the magnetic two-piece design securely snaps around a standard toploader. Every part can be printed in different filament colors, allowing you to personalize each build to match the card or your preferred color scheme.

**Commercial selling rights are available only to MysticMesh3D Authorized Merchants with an active Patreon subscription.**

#### **Features**

• Magnetic two-piece design

• Compatible with standard trading card toploaders

• Funny “NFS — Not For Sale” parody slab design

• Fully customizable with different filament colors

• Premium display piece for raw cards

• Great conversation starter for collectors and card shows

• Quick and easy to print

• Great for collectors, vendors, game rooms, card shops, and display cases

#### **Printing Instructions**

• Supports are required for the Front Plate.

• All other parts print without supports.

• Print each part in your preferred filament colors.

#### **Assembly Instructions**

Each NFS RawGuard requires:

• Eight (8) 5x2mm magnets

• Adhesive (CA glue or similar)

**Step 1**

Apply a small amount of adhesive inside each magnet pocket.

**Step 2**

Install all eight magnets, making sure the magnet polarity is correct before the adhesive cures.

**Step 3**

Apply adhesive to the back of the Label piece and attach it to the Label Border.

**Step 4**

Glue the completed Label Assembly onto the Front Plate.

**Step 5**

Allow all adhesive to fully cure.

**Step 6**

Snap both halves around a standard trading card toploader.